Search Results for ‘3.3 engine’

Hi Everyone, I have a 2002 Dodge Grand Caravan 3.3 V6 and I have a coolant leak which I cannot find where it is coming from. I added some coolant through the radiator and it obviously goes through the bottom radiator hose. When the radiator gets somewhat full, I notice that the coolant drops...

I need help what part this called that’s leaking you can see sort of sludge build up (transmission fluid is leaking) not too bad but bad enough to leave a noticeable puddle in driveway So what part is it called and how bad of a job is it to do yourself? (1st picture is looking towards rear of van)

I bought a dodge caravan for $225 everything runs great on it except for it feels like it is shifting hard, I checked the trans fluid and it looks a little dirty so I'm going to change it but I was wondering how much it cost to replace or rebuild a transmission in my van? Thanks in advance for...

Will a 3.3L motor bolt up to the 3.8L trans?

The title describes it well. My 05 GC 3.3 v6 has been consuming a lot of power steering fluid and i'm guessing theres a leak somewhere but when I leave the car parked nothing leaks under the car. I would need help identifying where the leak could be. Thank you for your time everybody.

Hello All I currently have a 2008 TC Touring edition that I love. It replaced my 2004 Sonata that was totaled. The question that I have is that I am looking at getting a 2008 Dodge to use for deliveries in my bakery and I see that a lot of them have the 3.3L engine. Most of them have over...

Hello I'm new here looking for help,2000 caravan 3.3 flex fuel. 4spd stumbles and sometimes busks,no SES light on or even a flash when it happens,only does it on heavy acceleration or going to pass and not all the time,I can tell by the way it has to be motor related,idles and starts great has...

Hi, the starter in my 2000 Grand Voyager SE 3.3 flex fuel has the tell tale symptoms of contacts and plunger going bad. I would like to have them on hand before I actually pull the starter motor. Kits are available on Ebay and Amazon really cheap but they lack specific model application...

Had some very bad clunking noises on startup after about 6 months of lifter noise that wouldn't go away. I'm assuming I lost the lifter and that was the #1 valve clunking against the piston. It's now stuck. SO: I figure at best I need to remove the front bank head and get some valve work...