The Chrysler Minivan Fan Club Forums banner

harmonic balancer

  1. Slow motion of Harmonic Balnancer and Why you may have Squeaky belts.

    3rd Generation Chrysler Minivans: 1996-2000
    I really did not see this when the Van was on in full speed. When I slowed it down. Wow. Its been my problem all along!
  2. Harmonic Balancer

    4th. Generation Chrysler Minivans: 2001-2007
    The Haynes manual for the 2005 T&C 3.8L states that the bolt should not exceed 40 ft/lbs. of torque .... my question is: after some light tapping and utilizing a larger M10.9 bolt to press the balancer on to the shaft i got it about an 1/8" close to being seated against the timing cover before i...
  3. Does harmonic balancer need to be flush with crankshaft?

    2nd Generation Chrysler Minivans: 1991-1995
    I'm pressing on a harmonic balancer on a 1994 voyager, but I still have about 1/4 inch to go before it's flush with the end of the crank snout. The crank pully looks well lined up with the other pulleys - so can and should I stop there? Thanks!
  4. I cannot find a harmonic balancer installation tool!

    2nd Generation Chrysler Minivans: 1991-1995
    So I successfully removed the broken crankshaft bolt (and that was a headache and huge potential nightmare) - but now I cannot find the tool to install the harmonic balancer. And I don't know if this is because no one locally actually has it OR if they just don't know what the heck they're...
  5. Broken Center Crankshaft Pulley-Vibration Damper Bolt 1994 Plymouth Voyager SE 3.3

    2nd Generation Chrysler Minivans: 1991-1995
    Hi. My crankshaft pulley/harmonic balancer/vibration damper bolt is broken and there is nothing sticking out to grasp it with - so I will have to drill it out and then use an Ez-Out. I have used Ez-outs a couple times before but I've never done it on something so critical as a crankshaft - and...
  6. Harmonic balancer shake

    3rd Generation Chrysler Minivans: 1996-2000
    Hey everybody I'm kinda new here.. been diggin around for a while reading about the gates kit and stuff. So I ordered the kit and was going to put it on when I smelled coolant from the passenger side. Started the car and found a crack in the radiator right below the upper hose. And while I was...
  7. Harmonic Balancer Not Aligned

    3rd Generation Chrysler Minivans: 1996-2000
    Hi! I have a 1998 LXi. I've been having some belt issues lately. Started out with the belt falling off when it went through a puddle. Bought a Gates kit, installed it, and all was fine for about a week. Then it started squealing. I tried and tried to get it stop squealing to no avail. Finally...
Top