Search Results for ‘tcm’

2004 T&C 3.8 touring (approx. 145k miles): front end on jackstands, in gear revealed: taking tires/wheels off made easier to see axle shafts, etc.: ... but you can see it's somehow not consistently instructing the axles to spin smooth & uninterrupted NOTE: in an '01 T&C i've experienced a...

Ryan Leis MegaShift on Chrysler 41TE automatic transmission using Bernard Fife aka "Lance " firmware So I got a message from Ryan about how and why he did this. And it was not just an exercise on taking advantage of the extra performance and flexibility you get with a custom transmission...

As you all read before, the transmission in my 2001 Dodge Grand Caravan, that is saving me from complete homelessness, was malfunctioning whenever I drove over 40MPH. After my initail mechanic just flat out refused to help me and just told me to "buy a newer car", I managed to find a...

I recently replaced the gasket on the TCM and now my instrument cluster error code readout comes up with E100.3, E100.7 and E400.1. The van is a '03 Dodge G.C. with approx. 330k kliks on it so the tranny shifts just a tad weird sometimes at slow speeds but other than that it seems to run fine. I...

My Caravan had a short circuit in a power seat motor. After this, my keyless stopped working, the speedometer stopped too, and the transmission came to LIMP MODE. The car doesn't shift gears. Just 2nd. I checked output sensor, transmission, and has no problem. People told me that this is a...

Got a 2002 T&C 3.3L , 4spd AT. Got a P1698 code. Here is what I have done so far after reading all the posts : Checked continuity TCm to PCM to DLC , all OK Got grounds on TCM terminals 53 & 57 Got 12Volts on pin 56 , but no 12V on pins 8 & 11 . Transmission remains in limp mode . When I turn...

Can a used BCM be used?I know it would need to be reflashed,is this possible?Or is there a way for the dealer to check just the BCM or the TCM?