The Chrysler Minivan Fan Club Forums banner

2003 T&C Axle shaft replacement hints?

607 Views 2 Replies 3 Participants Last post by  el conquistador
Replacing Dr side axle shaft/CVs. Got old one out no prob. Can't seem to get new one into tranny all the way. Splines are aligned and it's part way in but I don't think it's in to the point of the circlip making. Any good tricks for driving it home? How do the pros do this? Help!
1 - 1 of 3 Posts
I use the axle as a slide hammer. what I mean is that I hold the inner joint in with one hand then pull on the outer joint and slam it in. a couple cycles doing this and it snaps in. Using a soft face, shot filled, dead blow hammer is acceptable.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top