The Chrysler Minivan Fan Club Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
I have a 2015 T&C and I need to disconnect this fuel pump module electrical connector for a repair. I'm hoping someone can tell me just where this connector is:

Automotive design Automotive lighting Auto part Automotive exterior Font


I've looked around underneath (I believe that's underneath) but I'm just not seeing it. Does anyone know where this is or how it's oriented?

TIA
 

· Registered
Joined
·
24 Posts
Discussion Starter · #3 ·
Relieving fuel system pressure according to the FSM, but never mind, I found it. From the picture I thought it was mounted to a side rail, but it's a cross member behind the tank. Came off one-two-three and after only one start pressure was gone.

I'm blind sometimes.

Thanks for replying.
 

· Registered
Joined
·
24 Posts
Discussion Starter · #5 ·
It's underneath the car, behind the gas tank, mounted to the underside. It's just a 4-pin electrical connector, easy to disconnect. Doing so, then running the engine as many times as necessary (until it doesn't start) relieves fuel system pressure, which allowed me to remove the fuel manifold bars without getting sprayed by gas under pressure (I had an injector to replace).
 

· Registered
Joined
·
24 Posts
Discussion Starter · #7 ·
I did that, but it never started and I suspected it never bled off pressure. I put the fuse back in, disconnected the connector in back, and got one good start. After that it never did and all my fuel pressure was gone. It seems like pulling that fuse would accomplish the same thing, but for some reason it didn't.
 

· Registered
Joined
·
24 Posts
Discussion Starter · #9 ·
You unlock the red tab by pushing it sideways and then push in the catching tab while pulling the connector apart. It came apart easily. I was surprised at how clean everything was even after 122K on the car. Nonetheless, I put a smear of silicone (dialectric) grease on the halves before putting it back together. I suspect I'm going to have to do this again as the injectors go bad one by one (or have to for some other reason).
 
1 - 5 of 5 Posts
Top