I am getting ready to replace my front crankshaft bearing.......but I would like to get it up on a jack stand rather than leave it on a jack.
What I can't figure out is how to get it up on a jack and then get the jack stand in since they both us the same hoist point at the right front.
I looked in the manual and did not see an alternate jacking point on the right front ??
Any suggestions ?
What I can't figure out is how to get it up on a jack and then get the jack stand in since they both us the same hoist point at the right front.
I looked in the manual and did not see an alternate jacking point on the right front ??
Any suggestions ?
